M-100 Message Board
M-100 Message Board
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 M-100 Message Forum
 General Discussions
 EPC Online Access
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

rialto9

Australia
65 Posts

Posted - 02/05/2019 :  07:05:28  Show Profile
Hi all M100 friends,
Has anyone an idea if and when EPC Online is going to be available for MB Club members ?
I believe Daimler AG is opening an new portal for EPC, WIS etc.

Greetings from Western Australia

Walter

Art Love

Australia
6258 Posts

Posted - 02/05/2019 :  15:24:37  Show Profile
Based on a note I recently received from the M-B Club of Qld, the new system XENTRY should be up and running this month - February.
Art
Go to Top of Page

rialto9

Australia
65 Posts

Posted - 02/05/2019 :  17:29:42  Show Profile
Thanks Art
Go to Top of Page

wpmilby3

USA
61 Posts

Posted - 02/06/2019 :  10:52:32  Show Profile
You can try this mbepc.net
Will
Go to Top of Page

rialto9

Australia
65 Posts

Posted - 02/06/2019 :  17:41:56  Show Profile
Amazing, did not know this existed.
I entered my AUS VIN and it understood it and came up with the data card - different format though. Seems to be based on original EPC.
The entire system is a different format, but have already played with it. Have not worked out yet how to proceed to finding part numbers AFTER ENTERING THE VIN FIRST. I have found part numbers WITHOUT entering the VIN.

I'll continue to play with it.

Thanks Will
Go to Top of Page

wpmilby3

USA
61 Posts

Posted - 02/06/2019 :  19:34:55  Show Profile
It does take some effort playing with it. Finding transmission and engine part numbers takes some clicking on what you think is the right link but is difficult to figure out, but it is there.
Will
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
M-100 Message Board © 2002-2015 International M-100 Group, Inc. Go To Top Of Page
This page was generated in 0.31 seconds. Powered By: Snitz Forums 2000 Version 3.4.06